Tripp-Lite B004-2DUA2-K El Manual Del Propietario página 15

Basic Operation
Hotkey Setting Mode
All configuration of the KVM's settings takes place in Hotkey Setting mode. All
commands in Hotkey Setting mode start by entering the Hotkey Setting Mode Activation
Command. When Hotkey Setting Mode is activated, the [Scroll Lock] and [Caps Lock]
keyboard LEDs flash in succession and ordinary keyboard and mouse functions are
suspended. The section that follows describes how to activate Hotkey Setting mode, and
the commands that can be performed in it. A table at the end of this section summarizes
all of the commands.
Hotkey Setting Mode Activation Command
To activate Hotkey Setting mode, do the following.
1. Press and hold down the [Num Lock] key
2. While holding down the [Num Lock] key, press and release the minus [-] key
3. After releasing the minus [-] key, release the [Num Lock] key
Alternate Hotkey Setting Mode Activation Command
The Hotkey Setting Mode Activation Command defaults at [Scroll Lock] [-], but can be
switched to use [Ctrl] [F12]. When switched to [Ctrl] [F12], the [Ctrl] key takes the place
of the [Scroll Lock] key, and [F12] takes the place of the [-] key. To activate the Alternate
Hotkey Setting Mode Activation Command, perform the following steps. To revert back to
the previous command, perform these steps again.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [H] key
Alternate Port Switching Hotkey Command
By default, the hotkey proceeding sequence used in Port Switching Hotkeys is [Scroll
Lock] [Scroll Lock]. To toggle between [Scroll Lock] [Scroll Lock] and [Ctrl] [Ctrl], do the
following.
1. Activate Hotkey Setting Mode using the aforementioned command
2. Press and release the [T] key
Keyboard Operating System
The B004-2DUA2-K and B004-2DUA4-K default keyboard configuration is for use with
PC compatible keyboards. If you have a Mac or Sun computer, you can enable the
KVM to emulate Mac or Sun keyboard commands. When enabled, your PC compatible
keyboard can be used to perform commands specific to Mac or Sun (See the Keyboard
Emulation section in this manual for details). To set the Keyboard Operating System, do
the following.
1. Navigate to the port whose Keyboard Operating System setting you wish to change
2. Activate Hotkey Setting Mode using the aforementioned command
3. Press and release the [F2] (for Mac), [F3] (for Sun), or [F10] (for Auto-Detect) key
When enabled for Auto-Detect, a pass-through keyboard mode is enabled in which
keystrokes are sent directly to the computer without first going through the Mac or Sun
emulator.
15