Tripp-Lite SmartOnline SU10KRT3U El Manual Del Propietario página 10

Connection
Connect PDU to Power Module
1
Follow the procedure in the Mounting section to mount the UPS
power module in the rack. Tighten all screws before proceeding.
2 A
Loosen the screw
the cover away from the contacts
secure the cover in the open position.
3 E
Align the PDU with the PDU connection terminals
rear panel of the UPS power module, then push into place.
Tighten all four screws on the PDU before proceeding.
Connect Battery Pack to Power Module
1
Insert the male battery pack connector
battery pack cable into the female battery pack connector
the power module. (Remove the female battery pack connector
cover for access.) Small sparks may occur – this is normal.
Note: The power module does not contain internal batteries.
Battery packs are charged prior to shipping, but maximum battery
backup runtime will not be available until the battery has been
charged for 24 hours. If additional battery backup runtime is
required, connect additional battery packs to the primary battery
pack's female battery pack connector
available you can still power up UPS system through its
"independent battery startup feature" which will supply UPS
power to connected equipment, but not provide battery backup.
See Startup and Shutdown section for more information.
201102089 93-2982.indb 10
continued
securing the PDU contact cover
C
. Tighten the screws
A
at the end of the
C
. If battery pack is not
B
. Slide
D
to
F
on the
2
3
B
on
1
10
C
D
A
B
B
A
C
F
E
7/11/2011 3:49:01 PM