Publicidad
Idiomas disponibles
Idiomas disponibles
Changing channels does not work properly.
If the original remote control required pressing
change channels, then press
after entering the channel number.
During learning, the blue ring emits a long blink after
pressing and holding key to be learned.
Memory is full or a bad capture has occurred. Avoid high-
ambient light sources, such as direct daylight and fluorescent
bulbs. Try readjusting positions of remote controls before
performing the procedure again.
No remote control of volume.
See "Changing Volume Lock" to lock/unlock volume.
If the above does not work.
Please visit: www.oneforall.com
Consumer Help Line: 1 (800) 315-0990
As you update your home entertainment system, One For
All® has a universal remote control that will fit your needs.
Please visit our Website at www.Oneforall.com to see our full
product lineup.
ONE FOR ALL® is the registered trademark of Universal
Licensee of the ONE FOR ALL® brand for North America.
Copyright 2010 by Universal Electronics Inc.
No part of this publication may be reproduced, transmitted,
transcribed, stored in any retrieval system, or translated
to any language, in any form or by any means, electronic,
mechanical, magnetic, optical, manual, or otherwise, without
the prior written permission of Universal Electronics Inc.
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide a
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
environments.
looking new.
components can cause malfunction and invalidate its
warranty.
to
on the remote control
21
Publicidad
