gopart 60L Manual Del Usuario página 9

OPERATION INSTRUCTIONS
CAUTION: The spreader settings are guidelines only. The spreader should be calibrated prior to application to
ensure accuracy.
The spreader settings are based on a walking speed of 3 MPH. Walking faster or slower will alter the spread ap-
plication rate. Exact rates depend upon the spreader itself and the accuracy of the person operating it.
ADJUSTING THE FLOW
1. For proper material flow settings refer to the spreading instructions section.
2. Move the bolt on flow control assembly to the proper setting and tighten.
3. Pushing the spreader forward at brisk walking speed to ensure consistent cover-
age of material.
4. To stop, move the flow control lever to the closed position before stopping.
CONSISTENT COVERAGE
To insure consistent coverage, make sure each broadcast pattern slightly overlaps
the previous broadcast pattern as shown in figures below. Your spreader comes with
adjustable deflector shields (shield down) to control the flow of Rock Salt or Ice Melt.
The approximate broadcast widths for different materials are shown in the application
chart.
WARNING: Do not over apply spreading material. Follow the recommended coverage rate for each product. Over
application will lead to damage and contamination. If spreading material accidentally hits or deposits to heavily,
soak the area thoroughly with a garden hose or sprinkler to prevent burning.
UK
9