Manual Operation - Cooper Lighting FW Serie Instrucciones

FW42PC_PCW 825-0142.qxd:FW Series 325-1094 Spreads.qxd
Step 2: Connect the black fixture wire to the black supply wire (hot). Secure
with a wire connector.
Step 3: Connect the white fixture wire to the white supply wire (neutral).
Secure with a wire connector.
Step 4: Connect the bare ground wire on the mounting bracket (D) to an
appropriate supply ground or grounded outlet box. Secure with a
wire connector.
Note: Be careful to connect the wires correctly. Make sure no bare strands
of wire are sticking out of the wire connectors.
Installing the bulb
Step 1: Rotate the lamp holding bracket and line up the pins on the bulb with the
holes in the socket.
Step 2: Snap the bulb securely into the socket.
Step 3: Reposition the lamp holding bracket over bulb and tighten the screw.
Note: When replacing the bulb, you must always use the same wattage and
type of bulb that was originally supplied with the fixture. Failure to do so could
result in damage to the fixture and bulb. This will void the warranty. Always
turn off or disconnect power before servicing to reduce risk of electrical shock.

Manual operation

You may choose to override the photo control. This will allow you to control the
fixture from a wall switch without the dusk-to-dawn feature.
Step 1: Snap the photo control cover (G) over the photo control on the face
of the fixture.
Call for customer service and/or missing or damaged parts (800-334-6871)
6/3/08
4
4:34 PM Page 4