Cooper Lighting FW Serie Instrucciones página 5

FW42PC_PCW 825-0142.qxd:FW Series 325-1094 Spreads.qxd
What to do if. . .
LIGHT DOES
NOT COME ON
LIGHT COMES ON FOR
ONLY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT COMES ON
RANDOMLY
Is there power to the fixture?
• Has the house circuit breaker tripped?
• Is the wall switch ON?
Is the bulb(s) plugged or screwed in completely?
• Is the bulb(s) good?
(Be careful not to over tighten.)
Is the light sensor able to determine darkness?
• Cover light sensor with electrician's tape. Wait 2-3
minutes to see if light turns on. If it does, the
sensor is receiving too much light.
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
Is the light sensor sensing reflected light?
• Cover light sensor with electrician's tape. Wait 2-3
minutes to see if light turns on. If it does, fixture is
receiving reflected light. Partially cover the light
sensor to block out the reflected light.
Is the light sensor in a shaded area?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light turns off, the fixture is
mounted in an area that does not allow enough
light to enter the light sensor.
Is the light sensor good?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light does not turn off, the light
sensor is bad. Call customer service.
5
6/3/08 4:34 PM Page 5