Caring For Your Speakers - Harman JBL 4367 El Manual Del Propietario

BI-WIRE CONNECTION (continued):
If you're bi-wiring with two stereo power amplifiers, connect the speakers according to the following illustration.
Left Speaker
Mid/Tweeter
Connection Connection
In either case, follow the instructions for the different connector types in Basic Single-Wire Connection, on page 4.
NOTE: For more information about various speaker-wire and connection options, contact your local JBL dealer.
CONTROLS/ADJUSTMENTS
The 4367 has stepped front-panel adjustments that let you balance the high-frequency (HF) range and ultrahigh-
frequency (UHF) range against the woofer.
You can use these controls to adjust the speaker's sound according to your room's acoustics or your personal taste. If
you want to return the speakers to their factory-shipped response, set the controls to "0 dB."
As with most speakers, the 4367 has transducers whose suspensions will take several weeks to "break in" and achieve
optimum performance. During this period, the balance between the woofer, HF and UHF drivers may change, so we
recommend that you adjust the HF and UHF controls accordingly.

CARINg fOR YOUR SPEAkERS

• Wipe the cabinet with a clean, dry cloth to remove dust. A damp cloth may dull the cabinet's finish. Do not use
volatile liquids such as benzene, paint thinner or alcohol on the cabinet.
• Do not spray insecticide near the cabinet.
• To remove dust from the grille fabric, use a vacuum cleaner set to low suction.
• Do not wash the grille in water, as water may fade the grille's color or make it uneven.
• If the surface of the woofer cone becomes dusty, you can carefully sweep it clean with a soft, dry calligraphy brush
or paint brush. Do not use a damp cloth.
6
Woofer
High-Frequency
Trim
Amplifier 1
Amplifier 2
Ultrahigh-Frequency
Right Speaker
Woofer Mid/Tweeter
Connection Connection
Trim