Get Started - SodaStream SOURCE Manual De Instrucciones

Ocultar thumbs Ver también para SOURCE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
GET STARTED – ASSEMBLY
1. Place Drinks Maker on flat, sturdy surface, in an upright position. Remove packaging
materials. To remove back cover: (i) Put your index finger in the hole;(ii) Grasp back
cover; and (iii) Pull away from unit. Set cover aside.
2. Remove seal and cap from cylinder. Tip Drinks maker forward and insert 60L*
cylinder into Drinks Maker: first downward into the hole in the base of the Drinks
Maker, and then upward into the valve fitting.
3. Turn cylinder clockwise until it stops. Hand-tighten only; DO NOT use tools.
4. Reinstall back cover: tilt back cover toward you; insert bottom tab into slot and push
the cover into place.
* The 60L cylinders produce up to 60 litres of sparkling drinks, depending on the level
of carbonation and type of Drinks Maker used.

Publicidad

Tabla de contenido
loading

Tabla de contenido