Bond BH7001-2 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
* Please keep the owner's manual for future reference.
* If you have opened the carton and removed all packages, please disregard STEP 1, See STEP 2 directly.
STEP 1. (1) Open the carton, make sure the top cover of the carton being open up as below Figure A.
(2) Lift off the carton carefully and be wary of
the accessories inside falling away.
(3) Take all the packing materials away. See
Figure A.
STEP 2. (1) Attach the legs to the body part
using 8pcs M6x18 screws and Leg-A to the
right side of the control panel.
(2) Screw in the M8x50 double end bolts to the
top part of the legs. S S S e e e e e e F F F i i i g g g u u u r r r e e e B B B . . .
STEP 3. Place the glass table top on the top
of the legs. The bolts should go through the
holes on the table top. See Figure C.
STEP 4 (1) Attach the fasteners to the bolts
then tighten up.
(2) Place the glass cover on the fire bowl. See
F F F i i i g g g u u u r r r e e e D D D . . .
STEP 5
E
F
H
STEP 1
A
STEP 3
C
G
I
5
STEP 2
B
STEP 4
D
STEP 5
(1) Check each part before using the
product. Make sure the gas supply
system is turned "OFF" before as-
sembling. See Figure E.
(2) Put the gas tank in the metal stand.
Make sure the gas tank sits on the
metal stand completely. Turn the wing
screw on the outer part of metal stand
clockwise to secure the gas tank
tightly. See Figure H, I.
(3) Locate the battery and remove the
plastic cover first. Unscrew the rub-
ber cap of the Electric Igniter, place
a AAA battery into the case. Make
sure the pole ("+") is towards the
cap. Screw the cap back to the
battery case tightly. See Figure F.
(4) Evently distribute the glass bead in the
top of the firebowl. See Figure G.