Troubleshooting - Bond BH7001-2 Manual Del Usuario

STUBBORN STAINS
• Stubborn stains, discoloration and possibly rust pitting can occur from exposure to harsh outdoor
conditions.
• Be careful not let any powder or solvent come in contact with painted or plastic components
as damage may occur.
MAINTENANCE
USING A LONG MATCH OR LIGHTER
• Store the appliance in a cool dry place away from direct sunlight.
• Make sure both the gas and the appliance are turned off before changing battery. Please refer to
the process of inserting battery.
• Protect your appliance with the cover when not in use.
• The propane cylinder must be disconnected and stored outdoors before the appliance can be stored
indoors.
• Use Manufacturer approved or supplied replacement parts and accessories only.
Otherwise may void the warranty of this product and result in a hazardous condition.
• Please contact the Manufacturer for information regarding replacement hoses, thermocouples,
igniters, lava rocks, etc.

TROUBLESHOOTING

PROBLEM
Igniter pin and burner are wet
Igniter battery is
incorrectly inserted.
Igniter pin cracked or broken
Pilot will not
light
Electrode wire is loose or
disconnected
Electrode wire is shorting
between valve and igniter pin
No gas flow
Regulator is not fully
connected to the tank
Pilot will not
Gas flow is obstructed
light using a
Spider webs or insect nest in
match OR
the venturi (end of burner
Main burner
tube) or pilot housing
will not light
after pilot is lit
Burner ports are clogged
CAUSE
9
CORRECTIVE ACTION
Wipe dry with a cloth
Check that battery is correctly inserted.
Call customer service for replacement
part
Reconnect wire to the igniter
box located inside the table
base behind the igniter button
Call customer service for replacement
part
Check if gas cylinder is empty. If yes,
replace.
Check LP tank connection.
Check hose for bends or kinks
Clean the venturi or pilot housing
Insert an opened paperclip into each of the
burner ports to clean them. Ensure the appl-
iance is off and all parts are cooled before
attempting to clean the burner ports