Secondary Quick Check; Primary Ignition; Secondary Ignition - Bosch FSA 450 Instrucciones De Servicio

FSA 450
...11. Software

11.4 Secondary quick check

• Display of
cylinder waveforms
• Single probe connection

11.5 Primary ignition

11.5.1 Display functions
• Parade
• Single Cylinder
• Raster
• Superimposed
• Firing Volts Barchart
11.5.2 Measurement functions
• 2 ms/div to 20 ms/div (Parade)
• 0.2 ms/div to 2 ms/div (Single Cylinder,
Raster, and Superimposed)
• Trigger position: adjustable from 0 to 100%
• Engine Analyzer Display Range: 10 Volts/
div to 500 Volts/div
• Selectable Ranges:
- 80 Volts - 600 Volts
• Selectable Trigger Cylinder
• Voltage Offset:
between bottom and top of grid
11.5.3 Record and storage functions
• Record and Playback movie of displayed
screens
• User selectable record time
• Save and Recall display screens

11.6 Secondary ignition

11.6.1 Display functions
• Parade
• Single Cylinder
• Raster
• Superimposed
• Firing kVolts Barchart
• Power/Waste Comparison (Wasted spark
ignition only)
Robert Bosch GmbH
Secondary ignition single
channels adjustable
11.6.2 Measurement functions
• 2 ms/div to 20 ms/div (Parade and Power/
Waste Comparison)
• 0.2 ms/div to 2 ms/div (Single Cylinder,
Raster, and Superimposed)
• Trigger position: adjustable from 0 to 100%
• Engine Analyzer Display Range: 1 kVolts/
div to 50 kVolts/div
• Selectable Ranges:
- 8 kVolts - 400 kVolts
• Selectable Trigger Cylinder
• Voltage Offset:
between bottom and top of grid
11.6.3 Record and storage functions
• Record and Playback movie of displayed
screens
• User selectable record time
• Save and Recall display screens
11.6.4 Electronic Ignition (DIS) Lead Hook-up
The corresponding ignition system is selected
in the Vehicle selection menu at Manual Vehi-
cle Set-up.
After you press the corresponding menu but-
ton in the Main menu, the following graphic
(shown here by way of an example with twin-
spark coils) is displayed with the connection
diagram. This
always be observed. Selection of the correct
ignition sequence must be followed.
Fig. 8: Connection diagram
EN | 39
channels adjustable
connection method must
1 689 979 945 (28.07.2006)