ELICA Elite 26 IX/A/60/VT Montaje Y Modo De Empleo página 21

Operation
The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
Control Panel
1. Button ON/OFF light
2. Button ON/OFF Timer: delayed switch-off
selected suction speed (power):
Suction speed (power) 1: 20 minutes
Suction speed (power) 2: 15 minutes
Suction speed (power) 3: 10 minutes
Intensive suction speed (power): 5 minutes
3. Button OFF / Decrease of suction speed (power)
4. Button ON / Increase of suction speed (power)
5. Display, showing:
a. Suction speed (power): LEDs L1 – L2 – L3 - L4
(flashing) light up according to the selected suction
speed (power).
Note: the L4 LED – intensive suction speed (power)
works for about 5 minutes, then the hood sets the
intermediate speed.
b. Timer: the LED of the selected speed flashes to indicate
that the timer is active.
c. Grease filter saturation: the L3 and L4 LEDs flash
alternately at short intervals of time.
d. Activated charcoal filter saturation: the L3 and L4
LEDs flash simultaneously at short intervals of time.
Reset of the filter saturation indicator: perform filter
maintenance, then press button 2 until the LEDs turn off.
Note: The activated charcoal filter saturation is normally
disabled and is enabled only if the hood is used in the filtering
version (with charcoal filter installed).
In order to activate it, proceed as follows:
- Switch off the hood
- Keep pressed simultaneously buttons 3 and 4, until the
LEDs L1 and L2 flash briefly.
Repeat the operation to disable; only LED L1 flashes briefly.
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
of the
21