Replacing The Bulb; Maintenance Of The Chimney Hood - SUNFEEL CS601BL Manual De Instrucciones

GB

7. REPLACING THE BULB

1
2
Figure 12
Note: Remove the holder on the LED bulb as shown in Figure 12.2. Put
the new LED bulb on the holder housing of the LED bulb you removed as
shown in Figure 12.1.

8. MAINTENANCE OF THE CHIMNEY HOOD

• Device should be unplugged or switch should be turned off before
cleaning and maintenance procedures.
• Metal filter should be cleaned once a month with hot soapy water or
in the dishwasher, if possible. (60 °C)
• Remove the aluminum cartridge filter by pressing on the spring
catches on the side. Do not refit before drying after wash.
• Outer surface of the extractor hood should be wiped with a damp
cloth soaked with soapy water.
• Make sure electronic parts do not contact with water or similar
materials.
• For inox products, using inox cleaning and maintenance products
available in the market will provide longer usage life for your device.
• Aluminum filters can be washed in dishwasher. After several washes,
aluminum filters may change colour. This is normal and filters do not
need to be replaced.
Always switch off the electrical
supply before carrying out any
operation
LED bulb does not operate is
possible to remove as shown in
Figure 12
A new bulb to be supplied from
service points is replaced with
the same reoperation.
Cables
sockets. The plug in should
be made according to previous
connection.
14
are designed with