Cleaning And Maintenance - Yamato PT 2000 DK Manual De Instrucciones

cod. 99382 - mod. PT 2000 DK
Switching on/off
NOTICE! Risk of product damage! Always maintain a minimum distance of 25
mm between the nozzle and the surface to be treated.
NOTICE! Risk of product damage! Never use the product with the air inlet
openings pointing downwards. Dirty air can be sucked in.
NOTICE! Risk of product damage! The product must always be used with one of
the cap nozzles.
WARNING! Risk of injury! Use the stand (F) for resting the device. Don't put the
device down on any inflammable surface.
- Attach the required cap nozzle.
- On/off
- Adjust the temperature by turning the temperature controller (C). The set temperature is
shown in the display (D)
- As soon as the work is completed pull out the mains plug and put the product on its
stand (F) to let it cool down.
WARNING! Risk of injury! Switch off the product and disconnect the mains plug
before all cleaning and maintenance work. Wait until all moving parts have come
to a complete stop and the product has cooled down.
Cleaning the product
Careful handling and regular cleaning ensure that the product remains functional and
efficient for a long time.
- Wipe down the product with a slightly damp cloth.
- Never spray the product with water or expose it to water.
- Never use detergents or solvents for cleaning. This can cause irreparable damage to
the product. The plastic parts can be eaten away by the chemicals.
- Keep the air inlet openings and nozzle clear of impurities and blockages.

Cleaning and maintenance