Publicidad
Idiomas disponibles
Idiomas disponibles
cod. 99382 - mod. PT 2000 DK
Read and observe the instructions for use before using for the first time.
General safety instructions
1.
> To operate this device safely, the user must have read and understood these
instructions for use before using the device for the first time.
> Observe all safety instructions! Failure to do so may cause harm to you and others.
> Retain all instructions for use, and safety instructions for future reference.
> If you sell or pass the device on, you must also hand over these operating instructions.
> The device must only be used when it functions properly. If the product or part of the
product is defective, it must be taken out of operation and disposed of correctly.
> Never use the device in a room where there is a danger of explosion or in the vicinity of
flammable liquids or gases.
> Always ensure that a device which has been switched off cannot be restarted
unintentionally.
> Do not use devices with an on/off switch that does not function correctly.
> Keep children away from the device! Keep the device out of the way of children and
other unauthorised persons.
> Do not overload the device. Do not use the device for purposes for which it is not
intended.
> Make sure to always wear the required personal protective equipment.
> Exercise caution and only work when in good condition: If you are tired, ill, if you have
ingested alcohol, medication or illegal drugs, do not use the device, as you are not in a
condition to use it safely.
> This product is not intended to be used by persons (including children) or who are
limited in their physical, sensory or mental capacities or who lack experience and/or
knowledge of the product unless they are supervised, or have been instructed on how to
use the product, by a person responsible for their safety.
> Ensure that children are not able to play with the device.
> Always comply with all applicable domestic and international safety, health, and
working regulations.
Electrical safety
2.
> The device may only be connected to a socket that is correctly installed and grounded.
> The fuse must be a residual current circuit-breaker with a measured residual current of
no more than 30 mA.
> Make sure that the power supply corresponds with the connection specifications of the
device before it is connected.
> The tool may only be used within the specified limitations for voltage and power (see
type plate).
> Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug
and not by the cable.
> Do not bend, crush, pull or drive over the power cable, protect from sharp edges,oil and
heat.
> Do not lift the device using the cable or use the cable for purposes other than intended.
> Check the plug and cable before each use.
> If the power cable is damaged immediately disconnect the plug. Never use the device if
the power cable is damaged.
> If the device is not in use make sure the plug is pulled out.
> Make sure that the device is switched off before plugging in the mains cable.
SAFETY
Publicidad
