Hdlink Pro 3D Displayport - Blackmagic Design HDLink Manual De Instalación Y Funcionamiento

HDLink Pro 3D DisplayPort

HDLink Pro 3D is easy to use because any valid video signal received by the SDI input is sent to
all outputs, i.e. DisplayPort and SDI outputs. HDLink Pro 3D automatically detects the format of
the incoming signal and displays the video on any supported DisplayPort, DVI or HDMI monitor.
HDLink Pro 3D features an indicator lamp to show the operational status of the unit:
Off - HDLink Pro is powered off.
Dim - HDLink Pro is powered on but is not receiving a valid SDI video signal.
Bright - HDLink Pro is powered on and is receiving a valid SDI video signal.
6 Channel Analog Audio Output
Valid video signals supported by HDLink Pro 3D include 2K, HD1080, HD720, NTSC and
PAL. Computer video formats are generally not supported unless they coincidentally
match a TV format. HDLink can be used to monitor the output of a Blackmagic Design DVI
Extender in either Video or Extender (computer resolution) modes. Detailed information
is available in the DVI Extender manual. Please see the following HDLink specifications
link on the Blackmagic Design website for a full listing of current formats supported via
DisplayPort displays. Check
HDLink is preconfigured for you, requiring no initial setup to connect. Your HDLink will simply
run without changing any settings, however, if you would like to update the firmware, enable 3D
stereoscopic dual stream input, modify settings or load custom gamma tables, then use the
HDLink Utility software. This can be downloaded from the Blackmagic Design web site support
page. Check www.blackmagicdesign.com/support/
HDLink Pro 3D uses the same software as other HDLink models and shares the same software
interface for changing settings including 3D LUTs. 3D and 1D lookup tables can be applied just to the
attached DVI/HDMI/DisplayPort display, or to both the attached display and SDI output of HDLink
Pro 3D. Lookup tables are always applied to all outputs when monitoring dual stream 3D video.
HDLink Pro 3D supports dual stream 3D HD-SDI monitoring from 3D camera rigs and decks.
The left and right "eyes" are connected to the SDI In A and SDI in B inputs of HDLink
respectively. HDLink Pro 3D muxes the dual stream inputs for display on a compatible 3D
monitor, and can even frame pack the signal on a HDMI 3D television. The loop-through SDI
output can also be used to output the left eye, right eye or 3D muxed video to other hardware
such as an SDI deck. Standard definition and 2K signals are not supported in 3D.
DisplayPort
www.blackmagicdesign.com/products/hdlink/techspecs/
SDI SDI SDI USB
In A In B Out 2.0
Input
HDLink Pro 3D DisplayPort
Power
Input
12V
14