Burner Connection To The Boiler - baltur TBML 80 MC Manual Instrucciones De Uso

BURNER CONNECTION TO THE BOILER

ASSEMBLING THE HEAD UNIT
• Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
generator's manufacturer.
• Fit the rigid pipe in the housing provided on the connection
flange and fasten it with the screw. This pipe will be cut flush
with the diffuser (see 0002934670).
• Position insulating seal 3 on the sleeve, placing cord 2 between
the flange and the seal.
• Fasten the Combustion Head unit 4 to the boiler 1 by means of
the stud bolts, washers and the nuts provided 7.
Completely seal the space between the burner sleeve and
the hole in the refractory material inside the boiler door with
suitable material.
8 / 34
0006081545_201305