Usage Notes - RCBS EASY MELT 2 Instrucciones Del Producto

TO USE:
1. Plug the AC power cord into the EASY MELT unit, then plug the other end of the AC power
cord into the correct AC receptacle.
2. Add ingots, or small pieces of lead to the melting pot, stacking them against the sides as
much as possible.
3. Using the Digital Thermostat, set the desired Melting Pot temperature. (See "Digital
Thermostat Operation" on pg. 8, and "Suggested Casting Temperatures" below for specific alloys).
4. Continue to add ingots, or small pieces of lead to achieve desired Melting Pot capacity.
Melting Pot capacity is 25lbs. of material. Do not operate EASY MELT with less than 1" of alloy
in Melting Pot.
5. Using a casting ladle (sold separately), dip it into the Easy Melt pot to fill with molten material.
Pour the material into the mould block using either the gravity or pressure pour method.
WARNING! Do not attempt to dip the mould block directly into the molten material in
the pot. Any moisture or oils on the mould block will cause a violent reaction creating the
potential for personal injury or death.
WARMING MOULD BLOCKS
1. After all material has been added to Melting Pot, rotate cover, to completely cover the melting
pot, this will speed up the heating process and aids in keeping debris out of melting pot.
2. The cover can also be used for heating Mould Blocks. Simply place Mould Block on top of
cover to warm while waiting for material in Melting Pot to reach desired casting temperature,
(Photo 1)

USAGE NOTES

• For bullet casting instructions, consult the instruction book you received with your bullet
moulds.
• When melting metals to produce an alloy, always be certain that you are using the
recommended metals and recommended amounts.
Suggested Casting Temperatures
Alloy Casting Temp. (
Pure Lead
1:20 Tin - Lead
1:10 Tin - Lead
Linotype
Wheel Weights*
*Composition & properties vary
Photo 1
7
F)
o
700
700
700
775
775