Kohler K-18865 Guia De Instalacion página 4

Groove
Steel Washer
Screw
Recommended Mounting
Hole Locations
1. Install the Faucet Body
Determine the mounting hole location based on the user's
preference. We recommend the faucet body be located at 45
degrees to the front of the sink.
Drill a 1-5/16" (3.3 cm) hole through the mounting surface
according to the surface manufacturer's instructions.
Install the rubber washer into the groove in the bottom of the
faucet body.
Position the hoses and shank through the mounting hole, then
properly position the faucet body.
From under the sink, slide the fiber washer and steel washer onto
the shank.
Thread the threaded ring onto the shank to secure the faucet
body to the mounting surface.
Thread the two screws into the threaded ring, then tighten with a
Phillips screwdriver.
1068887-2-A
Rubber Washer
Fiber Gasket
Threaded Ring
4 Kohler Co.