Installing Hardware - Reflecta RPS 10M CyberView X5 Manual Del Usuario

installing hardware

a. Connect the slide scanner to a power source.
1. locate the power switch on the lower right side of the scanner. make
sure the scanner is turned oFF.
3. attach the usB cable to the computer using the stadard usB adapter
end. attach the usB adapter end of the cable to back panel of the
scanner.
Inserting Mounted Slides
attention Before scanning...
make sure there is no lmstrip inside scanner before you insert the slide and
there is no slide inside scanner before you insert the lmstrip.
Please note the slide and lmstrip cannot be put into the
scanner at the same time.
mounted slides
1. insert the slide into the slot on the front of the unit, with the dull (emulsion)
side facing down
2. Plug the aC adapter into an aC power source
First before plugging it into the scanner.
7