Section 4: Maintenance; Maintenance; Maintenance Schedule - Generac GC3000C Manual Del Propietário

Section 4: Maintenance

Maintenance

Regular maintenance will improve performance and
extend engine/equipment life. Generac Power Systems,
Inc. recommends that all maintenance work be per-
formed by an Independent Authorized Service Dealer
(IASD). Regular maintenance, replacement, or repair of
the emissions control devices and systems may be per-
formed by any repair shop or person of the owner's
choosing. To obtain emissions control warranty service
free of charge, the work must be performed by an IASD.
See the emissions warranty.

Maintenance Schedule

WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
Procedure
Check engine oil level
Inspect general equipment condition
Check engine exterior and cooling fins
Inspect knife for damage and sharpness
Check knife attachment screws
Check hammer/spacers for wear -- reverse or replace as needed
Check air filter -- clean or replace as needed
Check tire pressure
Change engine oil
Inspect spark plug -- replace as needed
Owner's Manual for Chipper/Shredder
(000108)
Table 4-1. Regular Maintenance Checklist
WARNING
Risk of injury. Do not operate or service this machine
if not fully alert. Fatigue can impair the ability to
service this equipment and could result in death or
serious injury.
WARNING
Personal injury. Before performing any maintenance procedure
or inspection, stop the engine and allow all parts to cool.
Disconnect spark plug wire and keep spark plug wire away from
spark plug. Failure to do so could result in serious injury.
CAUTION
Personal injury. Wear appropriate personal protective
equipment at all times while operating and servicing
unit. Failure to do so could result in personal injury.
Before Each Use






st
1 time 5 hours
Maintenance
(000215)
(000688)
(000419)
Every 25 Hours




15