Bushnell 119598 Manual De Instrucciones página 40

Camera stops taking images or won't take images
1. Please make sure that the SD card is not full. If the card is full, the camera
will stop taking images.
2. Check the batteries to make sure that they are new alkaline or lithium AA
batteries. See note above about short battery life.
3. Make sure that the camera power switch is in the "On" position and not
in the "Off" or "Setup" modes.
4. Make sure that you are using a good quality SD card in your camera.
Bushnell recommends SanDisk
for 1920x1080 or 1280x720 HD video) .
5. If the SD card has its write protect switch in the lock position, the camera
will not take images.
6. If you have used an SD card in another device before inserting it in
your WIRELESS Trophy Cam HD, you might want to try formatting the
card using the "Format" parameter in Setup mode (make sure you have
backed up any important files first, as formatting will erase all previous
files). In some cases, other devices may change the formatting of the SD
card so that it will not work properly with the WIRELESS Trophy Cam
HD.
Camera won't power up
1. Make sure that you have installed at least 4 batteries (the required
minimum #) in the battery compartment, starting at the top, filling
battery spaces 1-4 with no "gaps".
Bushnell recommends using a full set of 12 Energizer
batteries in your WIRELESS Trophy Cam HD (the max. capacity).
2. Make sure that the batteries are installed correctly, observing proper
polarity. Always place the negative (flat) end of each battery in contact
with the spring side of its slot inside the camera.
3. After moving the switch from "Off" to "Setup" or "On", make sure that
the switch is correctly in position to ensure the proper mode (avoid
positions "between" two modes).
4. Do not move the switch directly from "On" to "Setup"-always move the
switch all the way down to "Off" first, then back up to "Setup".
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
• Check the battery indicator icon to see if battery power is full. The
flash will stop operating near the end of the battery life.
40
SD Cards up to 32GB (Class 6 or higher
®
®
Lithium AA