Installation Steps - LUND 26510026 Instrucciones De Instalación

Installation Steps

Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle and finding the holes in the rocker
panel. Note which holes correspond with the holes in the running board brackets. Mark the holes in the rocker panel with a grease pencil.
1
Beginning at the passenger side rear, remove and
discard tape covering upper mounting holes in rocker
2
Attach bracket using M8 Bolt, M8 Flat Washer, and M8
4
NOTE: Actual application may vary slightly from illustrations.
panel.
Remove tape to reveal upper
mounting hole location
Lock Washer.
Front passenger side shown
If there are non threaded holes, insert bolt plate
through mounting hole in rocker panel. Align the stud
on the bolt plate with the bottom hole on the right side.
NOTE: If there are threaded holes, proceed to Step 4
3
Attach bracket by first using M8 Washer, M8 Lock
Washer, and M8 Nut. Then rotate bracket down to install
M8 Bolt, M8 Washer, and M8 Lock Washer.
5
Page 2 of 4
Proceed to Step 5.
instead.
Align stud on bolt plate with this hole
NOTE: Use caution not to drop the bolt
plate inside the rocker panel.