Checking The Settings; Favourite Position ("My"); Activating/Deactivating The Motor - SOMFY Oximo 40 Manual Del Usuario

Setting the lower end limit
1) Place the roller shutter in the required lower end limit
position.
- If necessary, adjust the position of the roller shutter
using the Up or Down buttons.
2) Press the STOP/my and Up buttons simultaneously:
The roller shutter is raised in one continuous move-
ment even after the STOP/my and Up buttons have
been released.
3) Raise the roller shutter until it reaches mid-height.
4) Briefly press the STOP/my button to stop the roller shut-
ter moving and continue by adjusting the upper end limit.
Setting the upper end limit
1) Place the roller shutter in the required upper end limit
position.
- If necessary, adjust the position of the roller shutter
using the Up or Down buttons.
2) Press the STOP/my and Down buttons simultaneously:
The roller shutter is lowered in one continuous move-
ment even after the STOP/my and Down buttons
have been released.
3) Lower the roller shutter until it reaches mid-height.
4) Briefly press the STOP/my button to stop the roller shut-
ter moving.
5) Press the STOP/my button again until the roller shutter
moves up and down:
6) Press the RTS control point PROG button to program the
first control point:
The roller shutter moves up and down briefly.
The end limit positions have been programmed.

6.4 Checking the settings

- Check the setting of the upper and lower end limits using
the RTS control point.

6.5 Favourite position ("my")

The Oximo 40 DC RTS motor is supplied with a pre-
programmed favourite position which corresponds to almost
complete closure of the roller shutter (slats in sun protection
position).
To modify the pre-programmed favourite position, refer to
section 8.1.
Activating the favourite position
- Carry out 1 complete roller shutter Up and Down cycle up
to the upper and lower end limits to activate the favourite
position.

6.6 Activating/deactivating the motor

The Oximo 40 DC RTS motor can be deactivated for trans-
portation, during extended periods of storage or when
commissioning another RTS motor nearby, using the batte-
ry's PROG button.
This limits battery discharge and eliminates any risk of
spurious operation.
This function is operational after wiring.
Copyright © 2009 Somfy SAS. All rights reserved.
Oximo 40 WireFree™ RTS
1 2
or
3 4
1 2
or
3 4
5 6
PROG.
1 2
35