Optional Additional Settings; Favourite Position ("My"); Adding/Removing An Rts Control Point - SOMFY Oximo 40 Manual Del Usuario

Oximo 40 WireFree™ RTS

8. Optional additional settings

8.1 Favourite position ("my")

8.1.1 Modifying the favourite position
Check that the favourite position has been activated (see
section 6.5).
1) Place the roller shutter in the required new favourite posi-
tion (my) by pressing the Up or Down button on the RTS
control point.
2) Press the STOP/my button until the roller shutter moves
up and down:
The new favourite position has been programmed.
8.1.2 Deleting the favourite position
Check that the favourite position has been activated (see
section 6.5).
1) Press the STOP/my button:
The roller shutter starts to move and stops in the
favourite position (my).
2) Press the STOP/my button until the roller shutter moves
up and down:
The favourite position has been deleted.

8.2 Adding/Removing an RTS control point

Caution! no more than 12 control points can be program-
med in an Oximo 40 WireFree™ RTS
The procedure for adding or removing a control point is the
same.
- Access the battery's PROG button.
1) Press and hold the battery PROG button until the roller
shutter moves for a few seconds:
The motor is in programming mode for approxima-
tely 2 minutes.
2) Briefly press the PROG button on the RTS control point
(N) to be added or removed:
The roller shutter moves up and down,
The RTS control point has been programmed or
removed from the motor.
Note: The procedure indicated in the RTS control point
guide can also be followed (refer to corresponding guide).
38
1
or
my
1
my
Adding
1
PROG.
Removing
1
PROG.
Copyright © 2009 Somfy SAS. All rights reserved.
2
2
2
PROG.
N
2
PROG.
N