Replacing The Injectors - ROSIERES VG 40 Instrucciones De Instalación Y Empleo

GAS CHANGE :
The hob is set on a type of gas which is mentionned on the packaging and reminded on the
appliance sticker.
If you intend to connect to another type of gas, it is necessary to adapt the appliance as
follows :
Place the suitable jet (which will ensure a normal flow), and set the idling.
Do not forget to update the label with the new setting.

REPLACING THE INJECTORS :

Pull the pan support off, take the burner caps out. Unscrew the jets with a special key.
In the same way, place the right one and screw it home.
SETTING OF THE IDLING :
• Remove the control knobs by pulling upwards,
- Natural gas : Screw the by-pass screw fully home and then unscrew it two full turns.
Ignit the burner on minimum output (mark small flame) The low setting is well controlled
when the flames are reduced to a measurement of 3 to 4 mm and do not extinguish when
passing from maximum to low setting.
- butane propane gas: the setting is obtained by screwing by the by-pass screw fully home.
BURNERS CHARACTERISTICS
Natural
G 20 20 mbar
G 25 25 mbar
Butane
G 30
28-30 mbar
Proprane
G31-37 mbar
Flow of burner
Jet
Main flow
Setting of the air ring
Jet
Main flow
Setting of the air ring
Jet
Main flow
Setting of the air ring
3 kW
142
285 l/h
without setting
87
218 g/h
without setting
87
214 g/h
without setting
1,8 kW
105
171 l/h
without setting
71
131 g/h
without setting
71
129 g/h
without setting
- 23