Canopy Assembly; Rod Support Assembly - Craftmade Ellington E-KM52ABZ5LKRCI Guia De Instalacion

7. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws
in hanging bracket. Twist canopy to lock.
Re-insert screws (along with star washers)
that were previously removed (page 3,
Section 4) and secure all screws with Phillips
screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Rod Support Assembly.

Hook one end of rod to loop on motor
housing. Adjust rod support to top end of rod
so it holds the rod in place and tighten rod
support set screw. Allow rod support cap to
rest on rod support.
Install remaining rods in between motor
housing and rod support. If rods fall off easily,
re-adjust rod support (by re-adjusting rod
support set screw as described above) with
rods already installed.
hanging
bracket
rod support
set screw
rod
loop
page 6
antenna
slotted hole
canopy
canopy
rod support cap
rod support
yoke cover
motor
housing