Panacom MP-1124 Manual De Usuario página 10

Using 2-in-1 charger (charger + data cable)
The 2-in-1 charger may charge the battery through the mobile
phone.
1>Connect the data cable and charger
2>Connect the data cable of the 2-in-1 charger to the I/O slot
of the mobile phone.
3>Connect the charger plug of the 2-in-1 charger to the
appropriate power outlet.
4>During charging, the icon of battery status blinks until the
charging completes.
5>After charging, the battery icon stops flashing, and you can
pull out the 2-in-1 charger.
Note: If the battery voltage is too low and can't turn on the
mobile phone, the charging icon may appear on the screen
after several minutes. The mobile phone may be turned on or
off during charging.
Warning: Make sure that the local voltage and power match the
rated voltage and power of the 2-in-1 charger.
Switching on/off
1>Press and hold the Power key to switch on the mobile
phone. The screen shows the power on video.
2>Access to main screen interface.
3>Press and hold the Power key to select switching off the
mobile phone.
Using hands free kit
With the hands free kit, you can make or answer calls without
holding the mobile phone. When you inert the hands free kit
into the earphone port, the hands free kit can be used as the
handset and the microphone of the mobile phone.
Pg. 10
Keyp
Whe
auto
To un
Note
new
resum
Lang
The
Vietn
keyb
CAL
Mak
Call
• En
out b
•Us
clear
Note
arou
Mak
Pres
coun
front
call k
Diali
Som
direc
the e