Braun Silk-epil Xpressive 7681 Manual Del Usuario página 8

Charging
• Before use, charge the appliance. For best
performance, we recommend that you
always use a fully charged appliance.
Using the special cord set, connect the
appliance to an electrical outlet with the
motor switched off. Charging time is
approximately 1 hour.
• The green charging light (5a) flashes to
show that the epilator is being charged.
When the battery is fully charged, the
charging light shines permanently. Once
fully charged, use the appliance without
cord.
• When the red low-charge light (5b) comes
on, connect the appliance to an electrical
outlet via the special cord set to recharge.
As a safety feature, it may happen that
in a low-charge mode, the appliance
turns off. Then both charging lights flash
(green/ red). In this case, simply turn
back the switch to «0» and recharge the
appliance as required.
• A full charge provides up to 40 minutes of
cordless operation time. Maximum battery
capacity will only be reached after several
charging/discharging cycles.
• The best environmental temperature for
charging is between 5 °C and 35 °C.
Preparing your skin
Your skin must be dry and free from grease
or cream.
Optional skin cooling: For the first few
epilations or if you have sensitive skin, you
can use the cooling application, recom-
mended by dermatologists to help reduce
possible skin irritation.
• Ensure that the gel pack has been in the
deep freezer (***) for at least 2 hours (for
8
convenience you can store the gel packs in
the freezer).
• Insert the gel pack underneath the glove's
transparent foil. Use only with glove.
• Put transparent (cool) side of the glove on
your leg.
• Start cooling for approx. 1/2 minute, longer
if needed.
• Epilate the cooled skin area immediately.
• Repeat cooling and epilating until
completion.
• While epilating, please ensure your skin is
dry.
Important: Apply cooling glove to the same
area for no longer than 2 minutes. Keep away
from sunlight. Do not use gel pack when
damaged. Dispose of in household waste. Do
not use if you are hypersensitive, allergic to
the cold, or if your skin suffers from sensory
disturbances, when suffering from cardiac
diseases or arterial circulatory disorders.
Preparing the appliance
• Before use, always make sure that the
epilation head is clean.
• Always make sure that the epilation head
(2) is provided with a cap.
• To change caps, press their lateral ribs and
pull off.
• To change heads, press the release button
(6).
A How to epilate
1 Turning on
• Press one of the lock keys and turn the
switch clockwise to setting 2 (optimum
setting). For reduced speed, choose
setting 1 (soft setting).
• The «smartlight» comes on instantly
and shines as long as the appliance is
switched on. It reproduces an almost