Publicidad
Idiomas disponibles
Idiomas disponibles
the power to this Regent light fixture. By inadvertently turning off the power, the
mode of operation may be changed. If the mode of operation needs to be
changed, just flip up the light cover to find a helpful guide at your fingertips with
quick and easy instructions which will allow you to select the mode of your
choice. NOTE: The modes of operation ONLY apply to this Regent motion
lantern.
Step 1: Turn off the power at the main fuse/breaker box.
Step 2: Locate the inside light switch that will control your Regent motion
activated lantern.
Step 3: If you have a single light switch, remove the two screws that are holding
your current cover in place. NOTE: DO
NOT REMOVE THE COVER. The
Regent light switch cover is designed to
fit over your existing cover! If you have
a bank of light switches (several switch-
es together), locate the one switch that
will control your Regent fixture.
Remove the two screws, one directly
above and one directly below the
switch.
Step 4: Open the lid on your Regent light switch cover. Align the holes on the
Regent light switch cover over the holes in your current cover. Re-insert
the screws to secure it in place. NOTE: If your screws are not long
enough, it may be necessary for you to replace them with longer screws
to secure the Regent light switch cover over your existing cover (P).
Step 5: Turn on the power at the main fuse/breaker box.
Step 6: Turn the light switch to the "ON" position and close the lid on your light
switch cover.
How to select your desired feature
Mode of
operation:
Test Setting
Lantern should turn on with
motion both day and night.
Lantern should turn OFF
after 4 secs.
Motion Activated
(auto setting)
Lantern should turn on with
motion only at night and should
turn off after 4 or 12 min.
of no motion.
2 Hour
NIGHT TIME ON then
Motion Activated
Lantern should turn on
automatically at night 100%
brightness for 2 hours, then
reset to regular auto motion
setting for the remainder
of the evening.
Set slide switch
on sensor to:
TEST
AUTO 4 MIN
or
AUTO 12 MIN
NIGHT TIME ON
2 HR
(2 Hours)
Note: Once the lantern has
come on in the selected "Night
Time On" mode, you cannot
change the mode setting until
the next dawn. The lantern will
operate in the first "Night Time
On" mode selected
(2 hour, 4 hour, or 6 hour),
even if changed.
6
Do not remove your
current cover.
Place over
existing
cover.
P
How to set
power switch:
Keep the power to
the fixture on.
Keep the power to
the fixture on.
Keep the power to the
fixture on.
(continued)
Publicidad
