Advancing Cutting Line - SNOWJOE Sunjoe 24V-ST14 Manual Del Operador

m
WARNING!
Do not trim near electrical wires.

Advancing Cutting Line

NOTE: Your trimmer + edger uses 0.063 in. (1.6 mm) diameter
nylon line to cut grass and weed quickly and easily. In time,
the tip of the nylon line will become worn and the auto-feed
mechanism will automatically feed and trim a fresh length of
line. The cutting line will wear faster if the cutting is done along
sidewalks or other abrasive surfaces or heavier weeds are
being cut.
The trimmer + edger is equipped with an auto-feed head.
Bumping the head to try to advance the cutting line will
damage trimmer.
1. With the unit running, release the ON/OFF trigger switch.
2. Wait two seconds, and press the ON/OFF trigger switch.
NOTE: The cutting line will extend approximately 1/4 in.
with each stop and start of the switch trigger until the
cutting lines reach the length of the safety guard.
3. Resume the trimming + edging.
m
WARNING!
Do not operate the grass trimmer + edger
in a tree, on a ladder, or on a scaffold; this is extremely
dangerous.
m
WARNING!
Do not bump the unit on ground in attempt
to feed line or for any other purpose.
Maintenance
m
WARNING!
Make sure to remove the battery before
inspecting its parts.
m
WARNING!
Always wear protective gloves during
maintenance tasks. Do not carry out maintenance when the
motor is running or hot.
• Your cutting line can dry out over time. To keep your line in
top condition, store spare pre-wound spools or bulk line in a
plastic resealable bag with a tablespoon of water.
• Never use water or chemical cleaners to clean your trimmer
+ edger. Wipe it clean with a dry cloth.
• Plastic parts may be cleaned by using mild soap and a
damp rag.
• Always store your trimmer + edger in a dry place. Do not
allow any liquid to get inside it.
• Keep the motor ventilation slots clean.
IMPORTANT! To ensure product safety and reliability, repairs,
maintenance, and adjustments to this power tool should be
performed only with identical replacement parts. Contact your
authorized Snow Joe + Sun Joe
®
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
dealer or call the Snow Joe
®
Replacing the Spool + Clearing Jams
and Tangled Lines
m
WARNING!
Remove the battery from the battery
compartment before changing the cutting line.
m
WARNING!
Never use metal-reinforced line, wire,
or rope, etc. These can break off and become dangerous
projectiles.
NOTE: 16.4 ft. (5 m) single-line replacement spool
(model 24V-ST14-SPOOL) is available for use with the
24V-ST14 trimmer + edger. Visit snowjoe.com to purchase
this accessory online. Always use the recommended nylon
cutting line with diameter no more than 0.063 in. (1.6 mm).
Using line other than that specified may cause the trimmer +
edger to overheat or become damaged.
1. Press together both release tabs on the line spool cover
and remove the cover by pulling it straight off
(Figs. 23 & 24).
Fig. 23
Fig. 24
®
13
Spool cover
Spool releasing tab
(on both sides)
Spool cover