Revell Control LAMBORGHINI AVENTADOR POLICE Manual De Usuario página 7

4 START PREPARATION
The transmitter of the vehicle switches on
automatically when the joystick is
actuated. That means that only the
switch on the underside of the vehicle
has to be set to ON (4A). Note: The
vehicle operating time depends on the
quality of the batteries which are used!
The switch on the vehicle must be set to
OFF after use. Otherwise, a drive command
can accidentally be triggered, causing the
vehicle to drive away on its own, which
can lead to considerable damage.
6 VEHICLE CONTROL
Pressing the forwards/backwards button moves the model forwards or backwards (6A).
Pressing the left/right button on the remote control during travel moves the model left
or right (6B).
INSTRUCTIONS FOR SAFE DRIVING
GENERAL DRIVING TIPS:
• Always maintain visual contact with the vehicle and do not look at the transmitter!
• On initial driving attempts, there is a general tendency toward excessive movements
of­the­controls.­Make­sure­that­you­have­sufficient­room.
After a crash, always release the speed control immediately in order to prevent
damage to the electronics.
THE SUITABLE DRIVING ENVIRONMENT:
The­location­in­which­the­vehicle­is­driven­should­fulfill­the­following­criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
12
5 STEERING TRIM ADJUSTMENT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
If the vehicle pulls to the left or the
right without being steered...
use the trim lever to correct the wheel
alignment by turning it in the opposite
direction. The wheel alignment can be
found on the bottom of the vehicle (cf. 5).
TROUBLESHOOTING
Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
• Please replace with new batteries.
Problem: Transmitter does not work.
Cause: 1. The batteries were not inserted correctly.
2. The batteries do not have enough power.
Remedy: 1. Check whether the batteries are inserted correctly.
2. Please replace with new batteries.
Problem: The vehicle cannot be controlled with the transmitter.
Cause: 1. The batteries are depleted.
2. The connection between the transmitter and vehicle has been severed.
Remedy: 1. Insert new batteries.
2. When the model is further than 10 metres away, move towards the model
Additional tips and trick can be found online at www.revell-control.de.
SERVICE NOTES
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13