Hazards And Risks; User Instructions; Description Of The Control/Command Devices; Power Plug With Residual Current Device (Rcd, When Included) - Shott WP14000 Manual De Instalación

E N

6.6 Hazards and risks.

Attention to the inlet/outlet points because they can trap parts of the
body and/or hair and cause serious personal injuries and even death.
Pumps, filters, and other equipment/components of a pool filtration
system can operate under pressure. If not correctly installed they can
cause serious personal injuries and even death.
The product is powered electrically, so maximum diligence in its
installation and maintenance is required, in order to avoid danger. Please
pay particular attention to:
•
the conditions of its power cord, which must not be damaged;
•
do not use the product without its pre-filter basket (Fig. ?, # ?),
otherwise the product may jam or be irreparably damaged;
•
when using any type of stop valve make sure the line is completely
open as the product must never run with valves closed.
7

User instructions.

7.1 Description of the control/command devices.

7.1.1

Power plug with residual current device (RCD, when included).

Before turning on the product, always press the RESET button. Check
power plug with residual current device operations by pressing the TEST
button (T).
Do not attempt to repair or open the power plug with residual current
device; in the event of fault, replace the entire power plug with residual
current device with the power cord.
The power plug with residual current device does not replace mandatory
electrical safety components: the electrical system must meet current
international and/or national regulations. If necessary, contact specialised
technicians.
The power plug with residual current device is an additional electrical
safety component able to cut off a circuit in the event of fault. In order for it
to work, it must:
• always be in the vertical position,
•
always be clean and free of dust or water,
• be connected to a perfectly efficient ground line,
RESET
TEST (T)
Fig. 67
Product on: fast flashing led.
To turn on the product: press the ON/OFF button.
To turn off the product: press the ON/OFF button.
Nome file:
7528001 - ISTRUZIONI WP - IT-EN-ES-FR-DE-NL-ES
File name:
•
check residual current device operations before turning on the product.
7.1.2

Checking residual current device operations.

Plug the power plug with residual current device into the power outlet:
5. press the RESET button to allow the product to be turned on: the light
turns red.
6. press the TEST (T) button to test residual current device operations: the
light turns off and the residual current device cuts off electrical power,
therefore the product cannot be turned on unless the RESET button is
pressed again.
If the residual current device triggers (turns off the product) during product
use, unplug the power plug with residual current device from the power outlet
and do not use the product. Contact a specialised technician.
7.2

Foreseen use and adjustments.

7.2.1

Pump with timer (when installed).

Product off: slow flashing led.
34-102
Fig. 64
Pa
Fig. 65
Fig. 66
Rev. 0 05/10/2015