Shott WP14000 Manual De Instalación página 36

E N
P
ROBLEM
5. Power cord damaged. Wear and/or negligence.
6. Plastic components
damaged.
7. Low flowrate from
outlet
8. Low flowrate from
outlet
9. Low flowrate from
outlet
10. Low flowrate from
outlet
11. The product does not
work.
12. The product does not
work.
13. Water leak.
14. Water leak.
15. Loss of water from
mechanical seal.
16. Blocked rotor.
17. Blocked rotor.
Nome file:
7528001 - ISTRUZIONI WP - IT-EN-ES-FR-DE-NL-ES
File name:
C
AUSE
Wear.
The product is dirty
Hydraulic components
clogged or bent.
The impeller's blades are
worn out.
The pump has not been
primed correctly.
The thermal protector
has been triggered.
The thermal protector
has been triggered.
Gaskets or o-rings
incorrectly installed
Fast connections or
cover not tight.
A mechanical seal is
used to isolate the pump
body and the motor
body. Some drops of
water may flow out once
in a while this is normal,
especially after periods
of non use.
Foreign bodies block the
rotating elements of the
product (impeller or
cooling fan).
Blocked drive shaft, it
can happen after a long
period of inactivity.
ST
1 S
OLUTION
Contact specialised
technicians.
Replace.
Clean the product.
Clean and adjust
hydraulic components.
Replace the impeller.
Prime the pump.
Check that the water
temperature does not
exceed +35 [°C] and, if
necessary, add cold
water to the pool to lower
water temperature.
Blocked drive shaft,
follow the instructions in
Blocked rotor.
Check correct gasket
and o-ring installation.
Tighten fast connections
and cover.
If the leaks are
consistent Please
contact specialised
technicians..
Remove any foreign
bodies.
Do the following:
1. unplug the
product from the
power outlet;
2. make the drive
shaft turn 9-10
times, using a
screwdriver as
shown in Fig. 71;
3. insert the power
plug of the
product into the
power outlet.
Tab. 7
36-102
ND
2 S
OLUTION
-
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
-
Contact specialised
technicians.
Contact specialised
technicians.
Rev. 0 05/10/2015