Securing The Child; Technical Data - NORAUTO 2274436 Manual De Instrucciones

4. To fasten seat belt across child: lap portion of the vehicle seat belt should rest within
EN
both lower belt guides with buckle located on the outside of the child restraint. On the
side of the seat belt buckle, route the shoulder belt together with the lab belt under the
armrest. Route the lap belt under both armrests.
5. Place shoulder portion into the upper belt guide on the headrest so that belt lays
properly across child: on the collar bone, interior (A) to the shoulder (B).
6. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight
to make sure it is not twisted.
7. Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth and snug across child in all locations.
NOTE: Test by pulling on the child restraint and shoulder belt to ensure it is locked.
CLICK
WARNING: If lap and shoulder belt portions of seat belt and seat belt buckle are not all correctly positioned, restraint is not properly
installed as a booster seat.

SECURING THE CHILD

WARNING: If your child is not properly secured in the child restraint, they may be ejected in a crash, resulting in serious injury or death.
1. Place your child in the child restraint in a seated position.
2. The child should be seated against both the back and bottom of the seat with no gap behind the child. Do not allow the child to
slouch.
3. Pull the vehicle belt. Thread it through the car seat slots to the vehicle belt buckle. Insert the 3-point vehicle belt in the buckle until
you hear a click.
• A child restraint positions your child so that the seat belt fits across the strong bones of the hips and pelvis and not the abdomen, to
protect your child from injury.
• The shoulder portion of the seat belt should be positioned over the chest and collarbone, staying between your child's neck and
shoulder so that it does not touch the neck.
CARE, CLEANING AND MAINTENANCE, STORAGE
• WARNING: It's dangerous to make any alterations or additions to the device without the approval of the Type Approval Authority, also
dangerous not to follow closely the installation instructions provided by the child restraint manufacturer.
• WARNING: Do not attempt to disassemble the child restraint further than these instructions allow.
• WARNING: All car seats expire. Plastic and metal parts wear out over time. Contact the manufacturer if you are unsure when your
seat expires.
• When the chair is not provided with a textile cover, the chair should be kept away from sunlight, otherwise it may be too hot for the
child's skin. Although, the child restraint must not be used without the cover. The seat cover should not be replaced with any other than
the one recommended by the manufacturer. The cover constitutes an integral part of the restraint performance.
• Check regularly if everything functions properly.
• If any parts are torn, broken, or missing, stop using this product.
• DO NOT attempt to remove the foam under the seat pad.
• Keep the child restraint clean.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the product.
• Removable fabric covers and trims may be cleaned using warm water with a household soap or a mild detergent.
30
Wash in maximum 30 °C
Do not bleach.
• Remove the child restraint from the vehicle seat if not in use for a long period of time. Store the product in a cool, dry place, protected
from moisture and direct sunlight and somewhere your child cannot access it.
• Avoid placing heavy objects on top of the seat.
• It is normal for the fabric to colour from sunlight and to show wear and tear after a long period of use, even when used normally.

TECHNICAL DATA

Overall dimensions
(millimetre)
Weight
24
A A
B B
picture a
Do not tumble dry.
Do not iron.
Length
Width
Height
Do not dry clean.
490
460
670
5.1 kg