Lorell LLR84161 Manual De Instrucciones página 3

UNPACKING HEATER AND SET-UP INSTRUCTIONS
Unpack the heater, and remove the base from the package.
1. Make sure the heater is unplugged and is turned off.
2. Turn the heater upside down.
3. Align the two hole assemblies of the two half bases, and position them as shown in the figure above.
4. Insert the butterfly nuts, and tighten them securely.
5. Turn the heater upright.
OPERATION INSTRUCTIONS
1. Place the heater on a firm level surface that is free of obstructions, at least 3' (0.9 m) away from all walls,
furniture, curtains, plants or flammable materials.
2. Plug the heater into a grounded 120 V outlet. The buzzer will sound and the digital indicator will display the
room temperature. When the heater is switched on, the buzzer will sound whenever a key is pressed.
3. Power setting: Press the power key
: Fan circulates room air only, the heating elements are OFF.
LO: Fan and heating elements operate at 900 W.
HI: Fan and heating elements operate at 1500 W.
4. Temperature setting: When the heater is set to HI or LO, press the UP key
desired temperature between 5ºC to 35ºC in increments of 1ºC. If there is no further operation within 5
seconds, the setting will be saved. Once the temperature is set, the unit will select the operating mode based
on the following 2 conditions:
•
If the set temperature is higher than the room temperature, the heater will continue to heat until
the room temperature reaches the set temperature. Once the room temperature reaches the
set temperature, the heater will stop heating. The heater will resume heating when the room
temperature falls below the set temperature. The heater will switch on and off in order to maintain
the set temperature.
•
If the set temperature is lower than or equal to the room temperature, the temperature display
will flash, and the unit will stop heating. When the room temperature falls to below the set
temperature, the unit will resume heating. The heater will switch on and off in order to maintain
the set temperature.
LO
heat on
HI
heat on
, the operating modes are arranged in a circular sequence (HI-LO-
Fan
only on
Timer
on
Temperatue
is displayed
in degrees
Celsius
3
and DOWN key to set the
).