Using The Remote Control; Inserting Batteries - Lorell LLR84161 Manual De Instrucciones

5. Oscillation setting: The heater will oscillate by pressing the oscillation key
press this key again. This key is only valid when the heater is working.
6. Timer setting: When the heater is on, it can be set to turn off automatically in 0.5 to 9.5 hours.
•
Press the Timer key. The display will blink.
•
Press the Increase key
•
After settings have been made, the display will change back to show the room temperature.
•
To cancel the timer, press the timer pad and press the Increase key
appears in the display.
•
If the timer was set before the power outage, it will need to be reset after power is restored.
NOTE: Every time the heater is switched on, it will heat at high temperature for 2 minutes. The heater will then
operate according to the instructions below. When the room temperature reaches the desired set temperature
or if the set temperature is lower than or equal to the room temperature, the heating element will shut off
immediately. However, the fan motor will continue to run for about 15 seconds before shutting off. This is a safety
feature that is designed to protect the unit from overheating.

USING THE REMOTE CONTROL

The remote has 6 keys that have following functions:

Inserting Batteries:

•
Press down on the battery compartment cover and slide out.
•
Insert the batteries, making sure that the positive terminals are facing the proper direction marked inside
the battery compartment.
•
Close the cover by sliding it in.
Notes:
1. Use 2 "AAA" batteries (NOT INCLUDED)
2. Do not mix old and new batteries
3. Do not mix alkaline, standard (carbon-lined)
or rechargeable (nickel-cadmium) batteries
4. Remove the batteries from remote if it is
to be left unused for a long period of time.
CAUTION: This heater includes an Overheat Protection System that shuts the unit off if it overheats due to
abnormal conditions. If this occurs, turn the heater off, unplug it, and check for and remove any objects on or
adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.
CAUTION: This heater includes a safety tip-over protection feature, which will shut the heater off in case it is
tipped over. If, at any time, the heater does tip over, please put the heater back in the upright position. The heater
will resume its normal operation.
TROUBLESHOOTING
If the heater fails to operate, please follow these instructions:
•
Ensure that your circuit breaker or fuse is working properly.
•
Ensure that the heater is plugged in, and that the electrical outlet is working properly.
•
Check for obstructions. If an obstruction is detected, turn the heater off. Unplug the heater, and wait
a few minutes for it to cool down. Carefully remove the obstruction. Plug the heater back in and turn it
on, referring to the instruction manual.
and Decrease key
Press to switch the heater on, press again to switch off
Press this key to select the desired mode (HI-LO
Value adjustment key, press it to increase temperature setting or increase timer setting
Value adjustment key, press it to decrease temperature setting or decrease timer setting
Press this key to set the timer
Press this key to start or stop the oscillation
to set the desired time for the unit to turn off.
) to return to standby mode
4
once. To stop the oscillation,
and Decrease key
Remote
Battery
Cover
until 0.0