Operating Your Dehumidifier; Set Unit Upright; Set Up Drain Hose; Plug In Electrical Cord - Dri-Eaz LGR 2800i Manual Para El Usuario

OPERATING YOUR DEHUMIDIFIER

Set unit upright

NOTICE: If you transport an i-Series dehumidifier in a
horizontal position, set it upright and let it stand for at
least 30 minutes before you turn it on. When the
machine is horizontal, the oil from the compressor flows
into the refrigerant coils reducing the ability of the
dehumidifier to function. Letting the unit stand upright for
30 minutes allows the oil to flow back into the
compressor.

Set up drain hose

This unit automatically pumps out water on a regular
basis. This dehumidifier is equipped with a quick-
connect fitting for attachment to the provided 40 ft. (12
m) drain hose located in the side pocket. Unwrap the
entire hose and place the open end in a sink, drain,
110489Q #110128 (F410), #110133 (F411)
bucket or outdoors – anywhere that water can drain out
safely. If you use a bucket or other container for water
collection, check it regularly to prevent overflows.
NOTE: Uncoil and straighten the entire drain hose.
Do not leave any of part of the hose coiled on the
unit and do not place the end of the hose higher
than 20 ft. (6 m) above the top of the unit. Also
check for kinks, or obstructions that would restrict
the flow of water. Failure to do so may cause a water
backup in the pump resulting in leakage.

Plug in electrical cord

The i-Series dehumidifier should be plugged into a
GFCI-protected 115 volt outlet rated for at least 15 amps.
Remove the cord from its storage pocket and uncoil it.
Always plug the cord firmly into the unit first, and then
plug the other end into a suitable outlet.
3 Legend Brands, Inc.