Kenmore 116.32728 Manual Del Propietário página 9

The attached
hoseswivels to
makecleaning
easierinevery
direction,
swivel.
Remove the
hose from the
hose clip by
pulling
straight out
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
t_tl_1li Remove the
i Crevice telescoping
Tool wand from
its storage
Telescoping
position.
Wand
Remove the crevice tool from its storage
position !n the wand. Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length Turn the
locking ring to the LOCK position_ Attach
the extension wand onto the open end of
the hose°
Suction-
Wand Control Slide
Upper
Wand
Align the tabs on the extension wand with
the "J" slots in the hose. Push the wand into
the hose and twist to the right to lock.
To achieve maximum reach
with the attachments, Hose
add the crevice tool to
the end of the
Suction
wand by inserting
Control
and twisting slightly,,
Telescoping
Wand _
Tool
The dusting
brush or the
combination
brush may be
attached
directly to the
wand or
placed on the
end of the crevice tool_
TO OPERATE SUCTION
CONTROL SLIDE
Telescoping Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twist the suction control slide
to the open position. This wil! reduce suction
for ease of cleaning. \
Suction
Control
The slide is Slide
located on the
telescoping wand,
close to the hose,
Note: Return suction control slide to the
closed position for normal cleaning.
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching, Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over.
Make sure the carpet/bare floor selec-
tor is in the bare floor position.
Damage to the floor surface may
occur if the carpet setting is used.