Assembly Of Handheld Remote; Automated Learning Process./Activating Code - Craftsman BL52-LED Guia De Instalacion

11. Assembly of Handheld Remote Control. (cont.)
Attach black faceplate to front of wall control;
press down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover together
until you hear a click at each end, indicating that
the remote control cover has closed completely.
IMPORTANT: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if handheld remote control will not be
used for long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK." - When
disposing of household alkaline batteries, it is
best to check with your local and state recycling
or household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.

12. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be
programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set
slider switch on wall control to the ON position. Within
60 seconds of turning on the wall control, press and hold the
OFF button on the wall control for 5 seconds or until light
blinks twice.
Turn power off again for at least 5 seconds and then turn
power back on. Within 60 seconds of restoring the power,
press and hold the OFF button on the handheld remote
control for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the learning
process is complete--see Section 13 on the following page.
post
hole
remote control
cover, BOTTOM
diagram 3
page 10
post
hole
- 1 1
- 2 2
DIM ON
face-
plate
wall
remote control
control
cover, TOP