Canopy Assembly; Blade Assembly, Small Blades - Craftsman BL52-LED Guia De Instalacion

8. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screw heads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

9. Blade Assembly, Small Blades.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble
the blades. If screws are overtightened, blades
may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
small blades.
Locate the 10 remaining blade attachment
screws and washers in hardware pack. Slide a
SMALL blade through one of the narrow,
rectangular openings on lower band of motor
housing, aligning holes in blade with holes in
motor plate. [The motor plate is located inside
the lower band and is accessed from the
underside of the motor housing--refer to
drawing at right.] Insert 2 blade attachment
screws (along with washers) and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining small
blade.
NOTE: Tighten blade attachment screws twice
a year.
canopy
screw
small blade
motor
plate
page 8
hanging bracket
screw
canopy cover
motor housing
blade attachment
screws and washers