Set The Time - Surface SUVC300 Guia De Inicio Rapido

Plug in
1
Plug the included power cable into the
DC 5V jack on the back of the clock/
sanitizer.
Plug the other end into a power outlet
or surge protector.
Battery Backup
Your clock has a pre-installed battery
backup that will keep the time in case
power is interrupted (like by a power
outage, for example). To start using the
battery backup, pull the activation tab
above the battery door inside the battery
compartment. The protective film covering the battery will
come of with the tab and the battery will be activated.
If you notice that battery backup is no longer working,
simply replace the CR2032 coin-cell battery in the battery
compartment. Use a coin to turn the battery door and
unlock it. Then remove the door and access the CR2032
battery.
2
2

Set the time

Press and hold the
clock/sanitizer until the hours digits flash.
Use the VOL/SET + and — buttons on the top of
the clock/sanitizer to adjust the hour. Press
Use the VOL/SET + and — buttons to adjust the
minutes. Press
Use the + and — buttons to choose 12- (AM/PM) or
24-hour time. (12-hour time is the default.) Press
to finish setting the time.
button on the top of the
to set.
to set.