Surface SUVC300 Guia De Inicio Rapido página 3

3
Load up the sanitizer
Open the cover of the clock/sanitizer. Then place the
item you want to sanitize inside.
Note: The mirror on the inside of the cover comes
from the factory with a scratch-resistant removable
film. Pull the tab on the film's corner and gently
remove it before you start sanitizing.
Charge up, too!
The clock/sanitizer can
charge your mobile
device too! Just plug
your charging cable (not
included) into the charging
port inside the clock/
sanitizer.
4
Sanitize!
Close the cover and choose the sanitization cycle you want to
use.
For these items Use this cycle
Hard, non-porous Standard cycle
(like phones, tablets, (around 10
watches and remote minutes)
controls)
Fabric and soft Deep clean cycle
(around 20
porous
(like facemasks,
minutes)
toothbrushes, and
makeup brushes)
The indicator on the clock display turns on during
sanitization. It turns off when the sanitization cycle is complete.
To stop sanitization before the cycle is complete:
Press the button. The
flashes three times to indicate the cycle has stopped and it's
safe to open the cover.
Notes:
• The indicator flashes if the cover is open when you try to start
sanitization. For your safety, the sanitizer cannot proceed with
sanitization if the cover is open. Make sure the cover is completely
closed, then press the button again.
• You can use the deep clean cycle even for items that don't need it.
There's no harm done to the item—it just takes longer to finish the cycle.
To start:
Press the
button.
Press and hold
the button until
the indicator on
the clock display
flashes twice.
indicator on the clock display
3