Federal Signal Streamline LP3 Serie Instrucciones De Instalación Y Servicio página 4

To replace the lamp, proceed as follows:
A. L oosen the locking screw on lens and remove lens from housing by turning counter-
clockwise.
B. Remove the old LED by depressing the LED and turning counter-clockwise.
C. Replace LED with Federal Signal approved replacement LED listed in section IV.
D. Attach lens to housing by turning clockwise until seated.
E. Tighten locking screw on lens to secure.
F. Test light for proper operation.
III. SERVICE.
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be
accompanied by a Return Material Authorization. This R.M.A. can be obtained from a local
Distributor or Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction,
should be provided.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
IV. REPLACEMENT PARTS.
Description
LED module, 24V, Amber
LED module, 24V, Blue
LED module, 24V, Clear
LED module, 24V, Green
LED module, 24V, Red
LED module, 120V, Amber
LED module, 120V, Blue
LED module, 120V, Clear
LED module, 120V, Green
LED module, 120V, Red
Lens, Amber
Lens, Blue
Lens, Clear
Lens, Green
Lens, Red
Kit, LP3 lens gasket, LP3T gasket, LP3S gasket K858900353A
Part No.
K8107199A
K8107199A-03
K8107199A-04
K8107199A-02
K8107199A-01
K8107200A
K8107200A-03
K8107200A-04
K8107200A-02
K8107200A-01
K8589063A
K8589063A-01
K8589063A-02
K8589006A-03
K8589006A-04
-3-