Entering Your Security Code; Locking The Safe - STACK-ON PS-15-05 Instrucciones

ENTERING YOUR SECURITY CODE

To enter your own security code you will need to
follow the steps listed below:
1. A er installing the ba eries, locate the reset bu on
on the back of the door.
2. Press the reset bu on with a pen and then release
it, you will hear a beep (if the sound is turned on).
DO NOT SHUT THE DOOR UNTIL YOU HAVE
CONFIRMED THAT YOUR NEW SECURITY
CODE HAS BEEN ENTERED CORRECTLY.
3. With the door open, enter your own personal
security code, which can be 3-8 digits long, and
con rm your new code by pressing the ....
the electronic touch pad. You will have 3 seconds to
press the .... key otherwise you will have to start
over from step one. ere will be 2 beeps (if the
sound is turned on) and the green light will ash
twice if your code has been entered successfully.
Before you close the door, enter the new security
code and press the .... key to make sure the lock
releases the knob so you can turn it and retract the
live action locking bolts.
If the code fails, go through steps 1-3 again. If the
code works successfully, then you should lock the
safe.
When you open the safe in the future enter the
security code you have set followed by the .... key
and turn the knob.
If an incorrect security code is entered 3 times the
safe will beep 5 times (if the sound is turned on) and
the red light will ash 5 times resulting in the safe
being automatically locked out for 60 seconds before
you can try your code again.
time (if the sound is turned on) and the green light
will ash once when the lockout period is over.
If an incorrect security code is entered 1 additional
time the safe will beep 5 times (if the sound is turned
on) and the red light will ash 5 times resulting in the
safe being automatically locked out for 5 minutes
before the code can be tried again.
one time (if the sound is turned on) and the green
light will ash once when the lockout period is over.
Write your new combination on this form or store
your combination on our secure website at
key on
www.stack-on.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from children, not
inside the safe.

LOCKING THE SAFE

To lock the safe, close the door and turn the knob to
the le to the 12:00 position.
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds a er the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe. Also, when locking the safe,
always make sure the knob is turned completely
to the le to the 12:00 position. If the knob is not
turned to the 12:00 position during the locking
process, the locking mechanism will not lock.
e safe will beep one
e safe will beep
2
12
40659-1512