Battery Installation; Entering Your Security Code - STACK-ON 40-0000119 Instrucciones

For safes with multi-spoked handles, remove the spoke included
in the instruction sheet bag or protective foam. Screw the spoke
into the hub and hand tighten.
NOTE: Do not use this handle to move the safe.
Remove the key from the packet and follow the steps outlined below:
1. Remove the keypad face by pressing the tab and turning it as
shown in the illustration. The keypad can hang by the connecting
cable while unlocking the safe.
2. Insert the key in the key hole and turn clockwise 1/4 turn (until
stopped) in order to unlock the safe. Rotate the handle and open
the door.

Battery Installation

NOTE: When changing the battery, always hold the battery connecting cap while disconnecting or
attaching the battery. Do not pull on the wires. Doing so could cause the power supply to disconnect
from the lock.
This safe uses one 9V alkaline battery. Under normal use, batteries will last about 1 year.
When the battery is low, a red indicator light will appear on the
keypad after pressing any button. Be sure to test your battery
every six months by entering your code. If the low battery
indicator light appears, promptly replace the battery.
To replace the battery, remove the keypad face by pressing the tab
and turning the keypad face as shown in the illustration. Replace
the old battery and screw the keypad face back in place.
Electronic Lock
After installing the battery, the electronic lock is ready for use.
To use the lock for the first time, press the following numbers/symbols in the order provided: 1-5-9-#.
The factory preset code is 1 - 5 - 9 - # and should be changed before using the safe. It is the owner's
responsibility for safekeeping of the new code.
NOTE: You should change the entry code as soon as possible after opening the safe to insure
proper security.
After entering the factory code, turn the handle clockwise to open the door. You will have 5 seconds to
turn the handle before the locking mechanism is reactivated.

Entering Your Security Code

NOTE: This safe includes a red reset button located on
the inside of the door and covered with a removable
cap. To use the reset button, remove the cap.
When you have set your combination, replace the
cap securely over the reset button. Failure to do so
will compromise the safety and security of the safe.
TAB
TAB
2
12
40-0000119-2103