Sauder Edge Water 414844 Instrucciones De Ensamblaje página 17

Step 13
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (I) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (17K) to the DOOR (I). Use a GOLD 1"
å
MACHINE SCREW (50S).
Repeat this step for the other DOOR (I).
å
See the next step for DOOR adjustments.
å
17K
www.sauder.com/services
B
I
50S
GOLD 1" MACHINE SCREW
(2 used in this step)
414844
Stop
Mounting
screw
Hinge
A
Page 17