Publicidad
Idiomas disponibles
Idiomas disponibles
Position washers 25x8.5x5 (1), the right-hand soft case carrier (2) and the
footrest bracket (3). Apply Loctite 243 to AH screws M8x29mm and tighten
to 25Nm. Proceed in the same manner on the left side.
2
3
1
Position bushings 25x8.5x16.5 as shown in the figure.
8
Screw on the top case back plate with flat-head screws M8x60 (of the top
case back plate) at the front and flat-head screws M8x55 at the rear.
NOTE: When removing the seat, first slide the rear carefully under the top
case back plate. Then pull the seat off at the front end. This procedure pre-
vents damage to the parts.
Mounting alternative B (without top case back plate)
Mount collar bushings 23x8.5x11.5 (rear) and bushings 19x8.5x20 (front)
on the rear top section.
Publicidad
