KTM 62612020000 Manual Del Usuario página 9

Position washers 25x8.5x5 (1), the right-hand soft case carrier (2) and the
footrest bracket (3). Apply Loctite 243 to AH screws M8x29mm and tighten
to 25Nm. Proceed in the same manner on the left side.
2
3
1
Mount the handrails (left and right) with flat-head screws M8x55 (front), flat-
head screws M8x65 (rear) and bushings 19x12x9.5 (4) (rear).
4
9
Final steps in mounting alternatives A and B
Mount the pipe end caps on the soft case carriers.
Attach the soft cases on the left and right (the gray heat-protection film
should point to the rear). Pull the soft cases up and attach to the
Velcro closure (5). Make sure the seat lock (6) is not obstructed. Allow the
latch on the securing strap (7) to snap into place and tighten.
7
5
6
Tuck any excess strap length into the loop (8).
8