Publicidad
Idiomas disponibles
Idiomas disponibles
Cover Closure
See Figure 4, steps 7 - 10.
Figure 3:Installation
Correct Installation
Incorrect Installation
Miscellaneous Comments
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician.
FCC Warning! Modifications not expressly approved by Visonic Ltd. could void the
user authority to operate the equipment under FCC rules.
Limited Warranty
Digital Security Controls warrants that for a period of 12 months from the date of pur-
chase, the product shall be free of defects in materials and workmanship under normal use
and that in fulfillment of any breach of such warranty, Digital Security Controls shall, at
its option, repair or replace the defective equipment upon return of the equipment to its
repair depot. This warranty applies only to defects in parts and workmanship and not to
damage incurred in shipping or handling, or damage due to causes beyond the control of
Figure 4:Adjustment and Cover Closure
Digital Security Controls such as lightning, excessive voltage, mechanical shock, water
damage, or damage arising out of abuse, alteration or improper application of the equip-
ment.
The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of
any and all other warranties, whether expressed or implied and of all other obligations or
liabilities on the part of Digital Security Controls. Digital Security Controls neither
assumes, nor authorizes any other person purporting to act on its behalf to modify or to
change this warranty, nor to assume for it any other warranty or liability concerning this
product.
In no event shall Digital Security Controls be liable for any direct, indirect or consequen-
tial damages, loss of anticipated profits, loss of time or any other losses incurred by the
buyer in connection with the purchase, installation or operation or failure of this product.
Motion detectors can only detect motion within the designated areas as shown in their
respective installation instructions. They cannot discriminate between intruders and
intended occupants. Motion detectors do not provide volumetric area protection. They
have multiple beams of detection and motion can only be detected in unobstructed areas
covered by these beams. They cannot detect motion which occurs behind walls, ceilings,
floor, closed doors, glass partitions, glass doors or windows. Any type of tampering
whether intentional or unintentional such as masking, painting, or spraying of any mate-
rial on the lenses, mirrors, windows or any other part of the detection system will impair
its proper operation.
Passive infrared motion detectors operate by sensing changes in temperature. However
their effectiveness can be reduced when the ambient temperature rises near or above body
temperature or if there are intentional or unintentional sources of heat in or near the detec-
tion area. Some of these heat sources could be heaters, radiators, stoves, barbeques, fire-
places, sunlight, steam vents, lighting and so on.
Warning: Digital Security Controls recommends that the entire system be completely
tested on a regular basis. However, despite frequent testing, and due to, but not limited
to, criminal tampering or electrical disruption, it is possible for this product to fail to
perform as expected.
Important Information: Changes or modifications not expressly approved by Digital
Security Controls could void the user's authority to operate this equipment.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company
from which you orignially purchased it. If you are discarding this product and not return-
ing it for repair then you must ensure that it is returned as identified by your supplier. This
product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
© 2017 Tyco Security Products. and its Respective Companies. All
Rights Reserved. The trademarks, logos, and service marks displayed
on this document are registered in the United States [or other
countries]. Any misuse of the trademarks is strictly prohibited and
Tyco Security Products. will aggressively enforce its intellectual
property rights to the fullest extent of the law, including pursuit of
criminal prosecution wherever necessary. All trademarks not owned by
Tyco Security Products. are the property of their respective owners,
and are used with permission or allowed under applicable laws.
Product offerings and specifications are subject to change without
notice. Actual products may vary from photos. Not all products include
all features. Availability varies by region; contact your sales
representative.
Toronto, Canada • www.dsc.com • Printed in Israel • Tech. Support: 1-
800-387-3630 (Canada, US), 905-760-3000
LC-181
Instrucciones de instalación de detector con antienmascaramiento con espejo
Octa-Quad™ para exteriores
Introducción
Características del detector
• 8 detectores PIR Quad independientes patentados (Octa-QUAD™) que operan en una
configuración Quad real con verdadero reconocimiento de movimiento (TMR) para
cada uno de los 8 detectores PIR y procesamiento de movimiento central - puede
distinguir entre un intruso en movimiento y árboles y arbustos en movimiento.
• Óptica avanzada Black Mirror™ (patente pendiente).
Publicidad
